Category: 2012 E-Z-GO

Posted on by — Leave a comment

Karl Installed 310VT On His 2020 Polaris XP Pro 4

Joe: I mounted two 310VT’s In my 2020 Polaris XP Pro 4. An inch and a quarter pipe runs across the back of the front seats. There is a lot of room in the back and I cut the pipe and did A straight up, positioned off a short barrel AR platform but my reg rifles and shotguns Work also. I screwed down the stock mount in a step on the center console. The other side has radiator lines under same spot so I will use short screws. Regards Karl

310VT's In my 2020 Polaris XP Pro 4
310VT's In my 2020 Polaris XP Pro 4
310VT's In my 2020 Polaris XP Pro 4
310VT's In my 2020 Polaris XP Pro 4
Posted on by — Leave a comment

Marty Installed 310VT On His 2012 E-Z-GO RXV

Joe, these are going to be great. Easy mounting, but the screws for the shoe could be 1/2” longer. I decided to rivet the top holder for a cleaner look. Can’t wait to get them on the trail. I’ll do an Amazon review as well. BTW, whoever packed the second set let the screws out of the box. No worries, I had a couple laying around that worked fine Thanks, Marty
 

Marty thank you for this great idea.  We are going to increase the length on the gun butt screws as you recommended.

Marty used rivets to install our 310VT on his 2012 E-Z-GO RXV. I recommended he add a square plate to give the backing more support.

Joe, here’s a metal plate added. Should increase the life span. Tried these out on Sunday. Once I got the routine so getting them in and out, it was fine Thanks, Marty

Nice job Marty thanks for the idea and your recommendations. Joe

2012rx2 1